- Home /
- Intrusion - Access - Automation /
- M1 Automation & Security /
- Expanders & Accessories /
- Ness M1 CBus Interface V.3
Products
- Audio
- Cable
- Discontinued Items
- Fire
- Intercom
-
Intrusion - Access - Automation
- Access Control
- Alarms
- Automation - HDMI
- Beams
- Biometrics
- Contact Reed Switch
- Egress
- Electronic Locks
- Evacuation
- Glass Break Detection
- Infra Red
- Inovonics Wireless Devices
- Input Output Devices
- M1 Automation & Security
- PCB's
- PIR's
- PIR's - Radio
- Power
- Power Adapters
- PSTN
- Radar
- Strobe
- Temperature
- Viberation Detection
- Z Wave
- Medical
- Network
- Power
- Storage
- Video & Surveillance
Ness M1 CBus Interface V.3
Downloads
Details
-
Unit of Measure:Each
Description
The Ness C-Bus Interface Module interfaces the Ness M1G and M1EZ8 to the Clipsal C-Bus networks. The Interface connects to the M1 via "PORT 0" (RS232 port) on the M1 panel, (or EZ8 / EZ24 panel) and includes a second RS232 port for connection of M1 Ethernet modules if required.
The 101-236 interface allows for 2 way communications in that it not only sends C-Bus commands to C-Bus but also will listen and respond to C-Bus light changes.
Connection to the C-Bus network is done via the "Clipsal SIM" module onboard the interface and no other interface such as a C-Bus PCI is required.
The interface is a true plug and play interface with virtually no programming required to make it work. All lighting programming is done within the M1 via NessRP. The light No's 1-255 correspond to C-Bus Group addresses 1-255.
The Ness C-Bus Interface Module interfaces the Ness M1G and M1EZ8 to the Clipsal C-Bus
- Fully approved C-Bus Enabled Product
- Controls up to 256 individual C-Bus lights or outputs (Includes full dimming, On / Off or toggle commands)
- Connects to the M1 either into Port 0 or any Serial Expander module
- Connects directly onto C-Bus without the need for additional PCI Interfaces
- Supports C-Bus Touch Screens and other C-Bus modules to control the M1 system
- Any M1 event or status change can control modules on the C-Bus
- Allows interfacing of M1 Ethernet module, Phone control or NessRM software to control C-Bus modules